This block requires the micro:bit V2 hardware. If you use this block with a micro:bit v1 board, you will see the 927 error code on the screen.
on Logo Event
Run some code in your program when the micro:bit logo is pressed, touched, or released.
input.onLogoEvent(TouchButtonEvent.Pressed, function () {})The logo on the micro:bit works just like a touch pin. The logo will detect your touch. You can have code inside an event that will run when the logo is pressed.
Parameters
- action: the logo event to run your code for. The events are
released,pressed,touchedorlong pressed.
Example
Show a message on the LEDs when the micro:bit logo is pressed.
input.onLogoEvent(TouchButtonEvent.Pressed, function () {
basic.showString("I was pressed!")
})See also
micro:bit V2, logo is pressed, on pin pressed, touch set mode